Challenges in Mechanics of Biological Systems and Materials, Thermomechanics and Infrared Imaging, Time Dependent Materials and Residual Stress, Volume 2 of the Proceedings of the 2023 SEM Annual Conference & Exposition on Experimental and Applied Mechanics, the second volume of five from the Conference, brings together contributions to this important area of research and engineering. The collection presents early findings and case studies on fundamental and applied aspects of Experimental Mechanics, including papers in the following general technical research areas:
Advanced Thermographic Techniques for SHM
AM Composites and Polymers
Experimental Techniques in Biomechanics and Mechanobiology
Inverse Methodologies and Uncertainties in the Identification of Residual Stresses, Residual Stress IV
Low Cost Thermographic Applications
Multiscale Mechanics of Biological Materials
NDE and Process Monitoring
Residual Stress
Thermomechanics Time Dependence in Porous and Soft Materials
Chapter
1. Development of PEEK matrix polymer composite and additive
manufacturing by pellet extrusion method.
Chapter
2. Parkinsonian Hand
Tremor Mitigation with Enhanced Wearable Device.
Chapter
3. Quantitative
Measurement of Viscoelastic Properties of Soft Membranes Subjected to Finite
Deformations based on Optical Coherence Elastography.
Chapter
4. Open Source
Contour Method Analysis for Assessing Residual Stress in Weldments.
Chapter
5. Variation of initial bulk residual stresses in aluminum alloy 7050-T7451
and its effect on distortion of thin-walled structural parts.
Chapter
6. On
the Use of iDIC (Integrated Digital Image Correlation) for the Slitting
Method.
Chapter
7. A rapid procedure to re-construct S/N curve by using
harmonic components of thermal signal.
Chapter
8. Rapid Fatigue
Characterisation via Infrared Thermography of AM-CM Composites.
Chapter
9.
Condition Assessment by Thermal Emission (CATE) for in situ monitoring of
fatigue crack growth.
Chapter
10. Effect of geometrical discontinuities on
mode shapes stress maps using infrared thermography.
Chapter
11. Induction
thermography: influence of testing parameters for different crack geometry.-
Chapter
12. Numerical Simulation of the Heat Dissipation During the Fatigue
Test.
Chapter
13. A full experimental characterization of aged Nitrile
Butadiene Rubbers (NBR).
Chapter
14. Characterization of the Effect of Cold
Joints and Functional Grading in Stepwise Constructed Tensile Dog Bones with
Embedded Digital Image Correlation.
Christian FranckUniversity of Wisconsin-Madison, WI, USA;Karen KaszaColumbia University, NY, USA;Jon Estrada, University of Michigan, MI, USA;Rosa De FinisUniversity of Salento, Italy;Geir ÓlafssonUniversity of Bristol, UK;Suhasini GururajaAuburn University, AL, USA;Jevan FurmanskiUniversity of Dayton Research Institute, OH, USA;Aaron ForsterNational Institute of Standards and Technology, MD, USA;Pavan KolluruTexas A&M University, TX, USA;Mike PrimeLos Alamos National Laboratory, NM, USA;Tom BerfieldUniversity of Louisville, KY, USA;Cahit AydinerBogazici Universitesi, Turkey.
